Additional Information for TDF Presentation

Slide 17

Triggers are special breakpoints that set other breakpoints. One trigger can set multiple breakpoints. Consider this example. A common subroutine is called from multiple points within a task but it is failing each time it is called from one of these points. The programmer could set a trigger at the calling point to set a breakpoint in the called routine.

Trigger commands can be entered via a panel or a line mode command.

Watch a 2 minute video

Copyright © 1998-2014 Arney Computer Systems. All rights reserved.      
Comments on this site? contact the Webmaster at

Arney Computer Systems, PO Box 382511, Duncanville, Texas 75138, USA
Tel: 214-306-0754     E-Mail: